Bleeding a house water pump removes air trapped in the system, restoring proper water pressure and flow. This typically happens when the pump has been idle for a while, causing air to accumulate.
Steps to Bleed a House Water Pump:
- Locate the Bleed Valve: The bleed valve is usually a small, screw-like valve located on the top of the pump.
- Turn on the Water Supply: Ensure the water supply to the pump is turned on.
- Open the Bleed Valve: Slowly turn the bleed valve counterclockwise until water starts flowing out. You may hear air escaping along with the water.
- Continue Bleeding: Keep the valve open until only a steady stream of water comes out.
- Close the Bleed Valve: Once water flows freely without air bubbles, close the bleed valve by turning it clockwise.
- Check for Leaks: Inspect the bleed valve for leaks. If any leaks occur, tighten the valve slightly.
Additional Tips:
- If you have a well pump, you may also need to prime the pump after bleeding it. This involves filling the pump chamber with water.
- You can use a small bucket or container to collect the water that drains out during bleeding.
- If you're unable to locate the bleed valve or are unsure about bleeding your water pump, contact a qualified plumber.
